Operating the PRIMEDIC™ DefiMonitor XD
DefiMonitor XD 21324 / GB / K05
7.2.3 Manual mode (MAN Mode)
Pressing the MAN/AUTO button switches the PRIMEDIC™ DefiMonitor XD to manual
operating mode. Manual mode is now activated. Illuminated LED is the identification of this
state. For further information, see chapter 10.
The device switches over to Auto mode:
• when it is switched off and back on again or
• when the MAN button is pressed
7.3 Changing the configuration/setup
The device is configured at the factory.
Certain parameters can be changed in the setup menu. The new configuration remains stored
until it is changed again, irrespective of whether the device is switched off or the power module
replaced.
Press the selection / confirmation key during operation to open the setup menu
.
Press the key (up) or the key (down) to navigate within the menu and to increase or
reduce a selected parameter value and press the
key to select a parameter and confirm the
new entry.
To Next Page
Loading...
