Copyright © Prins Autogassystemen B.V. 2013 Page 3
Required equipment / tools / materials for installing a complete system
- Complete workshop toolbox ( wrenches, screwdrivers, cutters, pliers, ratchet, sockets )
- Car lift
- Portable computer : operating on Windows 98,W2000 or XP.
Internal memory : 16 Mb or more
Memory HD space : 5MB
Screen : 256 colours, advise colours 16 bits or more
Com port : 1 free COM port 1 or COM port 2 with a 9 or 25 pins connector
or USB
- Vehicle fuel system scan tool or OBD scan tool Prins ( part nr. 099/99928 )
- Exhaust gas analyser
- Multimeter
- Oscilloscope
- Prins VSI diagnostic software
- Prins VSI serial interface
- Prins VSI break out box ( part nr. 080/70090 )
- Torque wrench ( 10Nm )
- Portable light
- Assortment drill bits 4 to 12 mm
- Assortment cutters ( ø 20, 30, 50, 70 mm )
- Punching tool ø 70 mm
- Round file
- Portable drill or pneumatic drill
- Threading device ( male M6x1, M8x1, M10x1 )
- Pipe-flaring tool ( for 6 and 8 mm copper pipe )
- Air gun
- Vacuum cleaner
- Hot air gun
- Allan spanner for inlet couplings 3,5mm ( part nr. 099//9970 )
- Reducer adjustment tool ( part nr. 099/9960 )
- Molex extraction tool for VSI switch connector ( part nr. 090/9929 )
- Soldering iron, soldering tin
- Wire-stripping pliers
- Adhesive tape
- Adhesive sealant
- Thread locking compound
- Anti-corrosion agent / black body coating
- Gas leak detection device or foam leak spray
- Shrink sleeves
- Engine coolant
Vehicle check
- Check the vehicle drivability on petrol
- Check the fuel system for error codes ( scan tool )
- Check if the catalytic converter is in good condition ( exhaust gas analyzer )
- Check the condition of the ignition system ( spark plugs, cables, coil )
To Next Page
Loading...
