Printronix SL4M - Saving a Configuration

148
Chapter 4 Saving a Configuration
Saving a Configuration
You can save up to eight different configurations to meet eight unique print job
requirements. These configurations are saved and stored in the printer and
are not lost when the printer is turned off.
NOTE: If the Protect Config. option is enabled, the new configuration will not
be saved until the existing configuration is deleted.
Follow these steps to save a new configuration:
1. Press the key to enter the menu configuration.
2. Press the Right key until CONFIGURATION displays.
3. Press the ↵ key to enter the CONFIGURATION menu.
4. Press the Down key until the following option is selected:
5. Press the Left or Right keys to cycle through the options (1-8).
NOTE: Factory is not listed because changes made to the factory
configuration cannot be saved under Factory.
6. When the desired number displays, press the ↵ key to select it. The
following message displays briefly:
When processing is completed, the display shows:
NOTE: If the configuration number has been previously saved and Protect
Config. is enabled under the CONFIGURATION menu, the following
error message displays:
If the above occurs, see “Modifying a Saved Configuration” on page 152,
step 4.
7. Print your configuration and store it in a safe place for future reference.
Refer to
“Printing a Configuration” on page 154.
.
.
.
CONFIGURATION
Save Config.
1*
Saving
Configuration
Save Config.
X*
CONFIG. EXISTS
Delete First