Printronix SL4M - Thermal Commands

Thermal Commands
271
Thermal Commands
Table 23 lists PTX_SETUP commands which apply to thermal printers.
Table 23. Thermal PTX_SETUP Commands
Command Sub-Command Parameter Description
ENGINE ALM_WIDE wide width Set the Auto Label Mapping wide
width
(in units of 1/1000”; e.g., a
wide width value of 1000 = 1”),
which represents the width of the
image in the file sent from the host
which is to be auto label mapped
into several labels, each of which
will have a width of
narrow width .
# of labels= wide width/narrow width
(rounded down)
ALM_NARROW narrow width Set the Auto Label Mapping narrow
width
, which represents the width of
one auto mapped label (in units of
1/1000”; e.g., a narrow width value
of 1000 = 1”). This width should be
set prior to the
wide width . In
addition, it can never exceed the
physical width of the printer. If it
does, the
narrow width will be
automatically reduced to the Page
Width value set in the configuration
menu.
ALM_ENABLE N/W/* Set Auto Label Mapping to Narrow,
Wide, or Off. Enter N for Narrow, W
for Wide, or any other letter to
disable ALM. By default, only the
Narrow option is implemented.
EJECT Performs a page eject.
IMAGE_SHFT_H Value Shifts the image Value horizontally
in 1/1000” units. If
Value is out of the
specified range (-1” to +1”), the
command will be ignored.
IMAGE_SHFT_V Value Shifts the image Value vertically in
1/1000” units. If
Value is out of the
specified range (-1” to +6”), the
command will be ignored.
LENGTH Value Sets the page length in 1/1000”
units.