Printronix SL4M - Page 151

DIAGNOSTICS Submenus
151
7. Press the ↵ key to select Enable. An asterisk appears after Enable.
Setting Admin User to Enable allows the user to see hidden submenus.
8. Press the key go to the main menu.
9. Press the Right key until the following displays:
10. Press the ↵ key to enter the CONFIGURATION menu.
11. Press the Down key until the following message displays:
12. Press the Left or Right keys to cycle through the options (1-8 and
Factory). When the desired number displays, press the ↵ key to select it.
The following message displays:
NOTE: If the configuration number has not been saved previously, the
following error message displays:
If this error message displays, see “Saving a Configuration” on
page 148. Once you have saved a configuration, repeat the steps in
this procedure.
.
.
.
CONFIGURATION
Power-Up Config.
Factory*
Power-Up Config.
X*
CONFIG. DOES NOT
EXIST/Save First