Printronix SL4M - Page 217

Status Messages
217
TESTING HARDWARE
PLEASE WAIT
Yes Normal power-up
message. Printer is
running its initialization
routine.
No action required.
THE ↵ KEY IS
LOCKED
Yes A momentary status
message that appears
when an attempt is
made to change a
menu option or perform
a diagnostic print test.
By default, the
↵ (Enter) key is locked
when the printer
powers on.
1. Unlock the Enter
key by pressing
DOWN +
↵ at the
same time. (This
is the factory
default key
combination.)
2. A different unlock
key combination
will be in affect if
the Set Lock Key
option in the
Printer Setup
menu was used.
THE ↵ KEY IS
UNLOCKED
Yes A momentary status
message that appears
when the
↵ (Enter) key
is unlocked, permitting
configuration
parameters to be
changed.
1. No action is
necessary if you
want the
↵ key
unlocked.
2. Press the DOWN
+
↵ keyat the
same time if you
want to lock the
↵ key.
To Stop Press ↵
N/A Normal message when
a test print pattern that
will run continuously is
printing.
Press the ↵ (Enter)
key to stop printing
the test pattern.
Table 16. Status Messages
Displayed Message
Can User
Correct?
Explanation Solution