Printronix SL5000 - Page 105

105
Notes:
1
Appears only if the Real Time Clock option is installed.
2
Available only when Battery Monitor is set to Enable (in the
BATTERY CONTROL menu). Functional only when the printer is
connected to a power cart, via serial interface, and the cart has an
ICP (Intelligent Control Panel) option.
3
Appears only if a Symbol LA4121 RF card is installed.
4
Appears only if a Cisco card is installed.
PRINTER
MGMT
(page 277)
PNE Port
Mgmt Protocol
PNE Port Number
PNE Port Timeout
Status Port Numb
Mgmt Port Number
BATTERY
CONTROL
(page 274)
Battery Monitor
Time To Go
2
Percent Charge
2
Current Draw
2
Voltage
2
Amp-Hour Used
2
Time To Go Alert
2
High Volt Alert
2
Low Volt Alert
2
Low Volt Fault
2
WLAN
EAP
4
(page 272)
Auth Method
EAP Mode
EAP User (01-15)
EAP User (16-30)
EAP User (32-32)
Reset EAP User
EAP Pswd (01-15)
EAP Pswd (16-30)
EAP Pswd (31-32)
Reset EAP Pswd
GPIO
CONTROL
Refer to the GPIO
User’s Guide
.
DATE
1
(page 278)
Time/Date
KERBEROS
PARAMS
3
(page 269)
Kerberos Enable
Kerb. Pwd(01-15)
Kerb. Pwd(16-30)
Kerb. Pwd(31-40)
Reset Kerb. Pwd
KDC Port Number
Clock Skew Units
Clock Skew (SEC)
Tckt Life Units
Tckt Life (SEC)
Renew Life Units
Renew Life (SEC)