Printronix SL5000 - Specifying a Power-Up Configuration

90
Chapter 3 Overview
Specifying A Power-Up Configuration
You can specify any one of the nine configurations (1-8 or Factory) as the
power-up configuration:
1. Press the key until the following message displays:
2. Press the ↓ key until the following message displays:
3. Press the
+ or − key to cycle through the options (1-8 and Factory). When
the desired number displays, press the ↵ key to select it. The following
message displays:
NOTE: If the configuration number has not been saved previously, the
following error message displays:
If this error message displays, see “Saving A Configuration” on
page 88. Once you have saved a configuration, repeat the steps in
this procedure.
.
.
.
MENU MODE
CONFIG. CONTROL
Power-Up Config.
1*
Power-Up Config.
X *
CONFIG. DOES NOT
EXIST/Save First