167
TWINAX SETUP
TWINAX
SETUP
1, 2, 3
(from page 97)
Primary Sets
See page 168.
Set Text
Orientn
Twinax Type
IPDS 256 Bytes*
IPDS 1024 Bytes
5225
4234
Active
Char Set
Secondary Set*
Primary Set
5225
World Trade
Standard Char*
Extended Char
Cancel
IGP/DCU
Enable*
Disable
Lead-in
Chars
User Defined
Set 1 <%>*
Set 2 ¬¬$
Set 3 _%_
Alt.
Set 80-9F
Printable*
Control Code
LAC Option LAC Approx.
Translation
Tbl
4
Graphic Chek
Err
Enable*
Disable
Buffer
Print
Disable*
Enable
Secondary
Sets
See
page 168
.
Graphic Chek
Cod
60*
40 to FE
Enable*
Disable
On*
Off
Control By Host*
Left to Right
Right to Left
Host Override
Disable*
Enable
Format
Control
Disable*
Enable
Max. Print
Width
13.2 inches*
Printer Width
User
Defined St1
5
5F*
40 to FF
User
Defined St2
5
5F*
40 to FF
User
Defined Stp
5
5B*
40 to FF
Notes:
* = Factory Default
Italicized items are available only when you enable Admin User (in the PRINTER CONTROL menu).
1
This menu appears only if the CTHI option is installed.
2
This menu appears only if Port Type (under C/T PORT) is set to Twinax.
3
This menu appears only if the CTHI emulation (under PRINTER CONTROL) is set to Standard.
4
This menu does not appear if the IPDS emulation is installed.
5
This menu appears only if you select the “User Defined” option in the “Lead-in Chars” menu.
To Next Page
Loading...
