Printronix SL5000 - Page 184

184
Chapter 3 P-SERIES SETUP
P-SERIES
SETUP
(from page 183)
Auto LF
Disable*
Enable
Define LF
Code
LF = CR + LF*
LF = LF
Control
Code 06
8.0 LPI*
10.3 LPI
6.0 LPI
Control
Code 08
Elongated*
Backspace
Bold
Disable*
Enable
Overstrike
Enable*
Disable
Select
SFCC
1*
0 to 7F
EVFU
Select
Enable*
Disable
Alt.
Set 80-9F
Control Code*
Printable
1
SFCC d
Command
Even dot plot*
Double high
PSeries Dbl
High
Normal*
P3/4/6/9 Compat
FF valid at
TOF
Enable*
Disable
Text
Position
Bottom of Line*
Top of Line
Host
Command
Enable*
Ignore All
Ignore CPI
Ignore LPI
Notes:
* = Factory Default
1
When the CTHI option is installed, the factory default is Printable.
2
All three Form Length submenus work in conjunction. When you change the default in one submenu, the default
values in the other two submenus change automatically.
3
This menu does not display when the CT, TN5250, or TN3270 emulation is selected.
4
The factory default value depends on the width of the printer model.
5
All Form Width submenus work in conjunction. When you change the default in one submenu, the default values in
the other two submenus change automatically.
Reset Cmd
CFG Ld
Disable*
Power up config
Current config
Factory config
Form
Length
2, 3
4 or 6 inches*
4
00.0 to 24.0 inches
Form
Length
2, 3
101.6 or 152.4 mm*
4
00.0 to 609.6 mm
Form
Length
2
24 or 36 lines*
4
0 to 144 lines
Form
Width
3, 5
04.1, 06.6, or 08.5 inches*
4
00.0 13.6 inches
Form
Width
3, 5
104.1, 168.0, or 215.9 mm*
4
00.0 345.4 mm
Form
Width
5
41, 66, or 85 characters*
4
0 to 272 characters