Printronix SL5000 - Page 186

186
Chapter 3 P-SER XQ SETUP
P-SER XQ
SETUP
(from page 185)
Slew
Relative
1 to 15 lines*
1 to 16 lines
Text
Position
Bottom of Line*
Top of Line
Host
Command
Enable*
Ignore All
Ignore CPI
Ignore LPI
Reset Cmd
CFG Ld
Disable*
Power up config
Current config
Factory config
Form
Length
1, 2
4 or 6 inches*
3
00.0 to 24.0 inches
Form
Length
1
24 or 36 lines*
3
0 to 144 lines
Form
Width
2, 4
04.1, 06.6, or 08.5 inches*
3
00.0 to 13.6 inches
Form
Width
2, 4
104.1, 168.0 ir 215.9 mm*
3
00.0 to 345.4 mm
Form
Length
1, 2
101.6 or 152.4 mm *
3
00.0 to 609.6 mm
Form
Width
4
41, 66, or 85 characters*
3
0 to 272 characters
Notes:
* = Factory Default
1
All three Form Length submenus work in conjunction. When you change the default in one
submenu, the default values in the other two submenus change automatically.
2
This menu does not display when the CT, TN5250, or TN3270 emulation is selected.
3
The factory default value depends on the width of the printer model.
4
All three Form Width submenus work in conjunction. When you change the default in one
submenu, the default values in the other two submenus change automatically.