Prodigit 3350F Series - SYSTEM Commands

92 PRODIGIT
4.6.4. SYSTEM Set and Read the Status of 3350F
[SYStem
：
] RECall{ SP }m{ ,n }
Syntax：[ SYStem：] RECall{ SP }m{ ,n }{；NL}
Purpose： Recall the status of Loading which had been saved in the Memory
Description： This command is for recalling the status of Load which had been saved
in the Memory .
m(STATE)=1~10，n(BANK)=1~15。
If the operating module is other series, omit “n” and it will be operated in the BANK
Which has been shown on the display.
For Example
RECALL 2，15  Recall the status of Loading which had been saved in the 2nd and
15th BANK of the memory
REC 3  Recall the status of Loading which had been saved in the 3rd of
Memory. If 3350F is operated , it will be operated in the BANK which has been shown
on the display.
[SYStem
：
] STORe{SP}m{,n}
Syntax：[SYStem：] STORe{SP}m{,n}{；NL}
Purpose：Save the status of Loading to the Memory
Description：This command is for saving the status of Loading to the Memory.
m(STATE)=1~10，n(BANK)=1~15 .
If 3350F is operated, omit “n” and it will be operated in the BANK which has been
shown on the display
For Example
STORE 2，15  Save the status of Loading which had been saved in the 2nd and
15th BANK of memory.
STOR 3  Save the status of Loading to the 3rd memory . If it is operated with
3350F, BANK will be set the BANK which shows on the display.
3350F
BANK(n) 15
STATE(m) 10
TOTAL STATE 150