14 PRODIGIT
2-4. Grounding requirements
SHOCK HAZARD
1. It is requested to use the 3Pin plug connector only for 3350F mainframe to out of danger
when electric leakage. And the complete and proper grounded is necessary.
2. The 3350F Series high power load is equipped with three conductor cable which plugs in
an appropriate receptacle to ground the instrument's cover.
2-5. Adjust the feet
The 3350F Series high power load is equipped with feet and tilt stands installed and is ready
for used as a bench instrument.
The feet provide a good viewing angle for bench-top use.
2-6. Rack mount
The 3350F Series high power load is designed to permit mounted in a standard 19 inches
rack for system application.
2-7. Environmental requirements
For indoor use only
installation Category I
Pollution Degree 2
Altitude up to 2000 meters
Relative Humidity 80% RH Max
2-8. Observe the International Electrical Symbol listed below
Warning！Risk of electric shock.
Caution！Refer to this manual before using the meter.
To Next Page
Loading...
Need help?
General
