Prodigit 3350F Series - Table 4-4 B STAGE COMMAND SUMMARY; Table 4-5 B SYSTEM COMMAND SUMMARY

3350F Series Operation Manual 81
STAGE COMMAND REMARK
[STATe：] LOAD {SP}{ONOFF} {；NL}
[STATe：] LOAD {?} {；NL} 0：OFF 1：ON
[STATe：] MODE {SP} {CCCRCVCP} {；NL}
[STATe：] MODE {?} {；NL}
0|1|2|3
：
CC|CR|CV|CP
[STATe：] SHORt {SP} {ONOFF} {；NL}
[STATe：] SHORt {?} {；NL} 0：OFF 1：ON
[STATe：] PRESet {SP} {ONOFF} {；NL}
[STATe：] PRESet {?} {；NL} 0：OFF 1：ON
[STATe：] SENSe {SP} {ONOFFAUTO } {；NL}
[STATe：] SENSe {?} {；NL} 0：OFF/AUTO 1：ON
[STATe：] LEVEl {SP} { LOWHIGH} {；NL}
[STATe：] LEVEl {?} {；NL} 0：LOW 1：HIGH
[STATe：] LEV{SP} {LOW HIGH} {；NL}
[STATe：] LEV{?} {；NL} 0：LOW 1：HIGH
[STATe：] DYNamic {SP} {ONOFF} {；NL}
[STATe：] DYNamic {?} {；NL} 0：OFF 1：ON
[STATe：] CLR{；NL}
[STATe：] ERRor {?}{；NL}
[STATe：] NO {SP}GOOD {?}{；NL} 0：GO 1：NG
[STATe：] NG {?}{；NL} 0：GO 1：NG
[STATe：] PROTect {?}{；NL}
[STATe：] CCR{SP}{AUTOR2}{；NL}（Note1）
[STATe：] NGENABLE{SP}{ONOFF}{；NL}
[STATe：]POLAR{SP}{POSNEG}{；NL}
[STATe：]START{；NL}
[STATe：]STOP{；NL}
[STATe：]TESTING {?}{；NL} 0：TEST END，1：TESTING
Table 4-4B STAGE COMMAND SUMMARY
SYSTEM COMMAND: available for all module
COMMAND NOTE RETURN
[SYStem：] RECall {SP} {m [,n] }{；NL}
m=1~10 n=1~15
[SYStem：] STORe {SP} {m [,n] }{；NL}
m=1~10 n=1~15
[SYStem：] REMOTE {；NL}
RS232/USB/LAN
command
[SYStem：] LOCAL{； NL}
RS232/USB/LAN
command
[SYStem：] NAME {?} {； NL}
“XXXXX”
Table 4-5B SYSTEM COMMAND SUMMARY