3350F Series Operation Manual 63
Example 1: Once the editing of the 16 step test is completed, press the TEST key. The unit
Will then automatically run through the test steps S01 to S16 in order. If all tests
Steps have been completed then the LCD will show PASS.
Example 2: Once the edit mode has been used to set the 16 step auto-sequence the user can
Press the TEST key. If the test fails at one of the test steps the LCD will flash “NG”
And the test will stop. The user can then press ENTER key to continue the test or
Press the EXIT button to leave the test mode.
To Next Page
Loading...
Need help?
General
