PROEMION CANlink wireless 4001 - Page 92

Parameter Value
Data transfer rate
CAN messages per second that can be transmitted
without data loss
Tested with Baud rate: 1 Mbit/s
Bluetooth single point: tbd CAN messages per
second
WLAN Access Point, Single Point: tbd CAN messages
per second
WLAN infrastructure mode Single Point: tbd CAN
messages per second
Average latency period for transmission of a single CAN
message
Tested with Baud rate: 1 Mbit/s
Bluetooth Bridge Single Point: < tbd ms
WLAN Bridge Single Point: < tbd ms
Maximum Range
Tested outside at a free field without any barriers.
CAN messages sent per second: 1000
Baud rate: 250 kBit/s
Weather conditions during test: Cloudy with light
rain
Antenna: Dual-Band Bluetooth-/WLAN (part#
tbd)
Bluetooth, Single Point Mode:
4001: tbd m
4003: tbd m
WLAN / Access Point Mode, Single Point Mode
4001: tbd m
4003: tbd m
WLAN / Infrastructure Mode, Single Point Mode
4001: tbd m
4003: tbd m
The measured values in WLAN / infrastructure mode
mainly depend on the used WLAN access point
hardware.
The determined values are dependent on the used
antenna and ambient conditions.
Antenna Connector 4001: internal antenna
4003: FAKRA connector (male), code I (important: to
avoid losing the radio approval of the WLAN module, only
use approved antennas)
Buffer sizes: CAN receive buffer: tbd messages
CAN to wireless buffer size: tbd messages
Serial receive buffer (module to main controller): tbd
bytes
CANlink wireless 4000 Device Manual