ProMinent
®
Page 69
Customer Specification Form
Client:
Project number: Date:
q Sketch supplied:
Metering pump Type – ......................................................
Pump capacity l/h ......................................................
Stroking rate strokes/min ......................................................
Stroke length % ......................................................
Valve spring pressure, suction side bar ......................................................
Valve spring pressure, discharge side bar ......................................................
Chemicals Description/concentration –/% ............................ / .......................
Proportion suspended solids/particle size %/mm ............................ / .......................
Solid material/hardness –/(Mohs scale) ......................................................
Dynamic viscosity mPa s (cP) ......................................................
Density kg/m³ ......................................................
Vapour pressure at operating temperature bar/°C ......................................................
System: Suction side Pressure in suction container bar ......................................................
Nominal width, suction line DN/mm ............................ / .......................
Suction lift min./max. m ............................ /.......................
Suction pressure min./max. m ............................ / .......................
Length, suction line m ......................................................
Number of corner bends/valves – ......................................................
Pulsation dampener
q with diaphragm .......................... ltr.
q without diaphragm ..................... ltr.
System: discharge side Static system pressure min./max. bar ............................ / .......................
Nominal width, suction line DN/mm ......................................................
Length, suction line m ......................................................
Feed lift m ......................................................
Number of corner bends/valves – ......................................................
Pulsation dampener
q with diaphragm .......................... ltr.
q without diaphragm ..................... ltr.