ProSun V3 - Page 31

31
MARK76V3002 Rev 3
Guidance and Manufacturer’s Declaration – Electromagnetic Immunity
Non life supporting ME Equipment
The ProSun V3 Model 42V3 isintendedforuseintheelectromagneticenvironmentspeciedbelow.
The customer or the user of the ProSun V3 Model 42V3 should assure that it is used in such an
environment.
Immunity Test IEC 60601 Test
Level
Compliance
Level
Electromagnetic Environment – Guidance
Conducted RF
IEC 61000-4-6
AC Mains
3V with 6V ISM
80% AM at 1
kHz
150 kHz – 80
MHz
AC Mains
3V with 6V ISM
80% AM at 1
kHz
150 kHz – 80
MHz
Portable and mobile RF communications equipment should be
used no closer to any part of the ProSun Tanning Equipments,
including cables, than the recommended separation distance
calculated from the equation applicable to the frequency of the
transmitter.
Recommended separation distance
where P is the maximum output power rating of the transmitter in
watts (W) according to the transmitter manufacturer and d is the
recommended separation distance in metres (m).
FieldstrengthsfromxedRFtransmitters,asdeterminedbyan
electromagnetic site survey,a should be less than the compliance
level in each frequency range.b
Radiated RF
IEC 61000-4-3
3V/m,
80% AM at 1
kHz 80 MHz –
2700 MHz
(E1) = 3V/m
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE2Theseguidelinesmaynotapplyinallsituations.Electromagneticpropagationisa󰀨ectedbyabsorptionandreection
from structures, objects and people
aFieldstrengthsfromxedtransmitters,suchasbasestationsforradio(cellular/cordless)telephonesandlandmobileradios,
amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess
theelectromagneticenvironmentduetoxedRFtransmitters,anelectromagneticsitesurveyshouldbeconsidered.Ifthe
measuredeldstrengthinthelocationinwhichthe“ProductName”isusedexceedstheapplicableRFcompliancelevel
above, the “Product Name” should be observed to verify normal operation. If abnormal performance is observed, additional
measures may be necessary, such as reorienting or relocating the “ProSun Tanning Equipments.
bOverthefrequencyrange150kHzto80MHz,eldstrengthsshouldbelessthan[V1]V/m.