11 Important note for working in practice
23 of 54
11. Important note for working in practice
11.3. Simple stopping of the machine and the Emergency-Off switch
Press any key of the PC keyboard to stop the carriage movement and to switch off the
lathe. The system will then wait for further commands.
This "Keyboard Stop" is helpful during the test phase and for disruptions of machining
(e.g. wrong infeed, wrong feed).
11.4. Safety stop, lock
Press the "Lock" switch of the CNC control to stop the carriage movement and to switch
off the spindle. The system will not accept any further commands until the
switch/pushbutton is returned to the "ON" setting.
11.5. Direction of rotation switch
Your CNC machine no longer has a separate mains switch
as it is controlled directly via control electronics. However,
during normal work, make sure that the direction of rotation
switch of the machine (shown in the figure on the right) is
not in the "0" setting, but is set to the desired direction of
rotation. Otherwise the machine will not start.
That is why it also may not be set to "0" during a machining
procedure, as the spindle movement will be interrupted.
11.6. Room EMERGENCY Off
Room EMERGENCY Off: An EMERGENCY Off switch that disconnects the power
supply in the entire room must be installed in the room where the machines are
operated. This red/yellow coloured mushroom-shaped pushbutton must be easily
accessible and arranged far enough away from the possible hazardous area.
To Next Page
Loading...
Need help?
General
