Table of contents
2 Product details 6
3 Introduction - Glossary, Disclaimer, Safety instructions, Licenses 6
4 Original Prusa i3 MK3 printer 8
5 Original Prusa i3 MK3 printer kit 9
6 First steps 10
6.1 Printer unpacking and proper handling 10
6.2 Printer assembly 11
6.3 Setup before printing 11
6.3.1 Calibration flow and wizard 11
6.3.2 Flexible steel sheet surface preparation 13
6.3.2.1 Double-sided textured PEI powder-coated spring steel sheet 15
6.3.2.2 Double-sided glossy PEI powder-coated spring steel sheet 15
6.3.2.3 Spring steel sheet with smooth double-sided PEI 15
6.3.2.3 Aftermarket sheets 15
6.3.3 Increasing the adhesion 16
6.3.4 Selftest (kit only) 16
6.3.4.1 Selftest error messages and resolution (kit only) 17
6.3.5 Calibrate XYZ (kit only) 17
6.3.5.1 Calibrate XYZ error messages and resolution (kit only) 18
6.3.6 Calibrate Z 20
6.3.7 Mesh bed leveling 21
6.3.8 Loading the filament into the extruder 21
6.3.8.1 Unloading the filament 22
6.3.9 First layer calibration (kit only) 23
6.3.9.1 Bed level correction (kit only) 24
6.3.10 Fine-tuning the first layer 24
6.3.10.1 Print prusa logo 24
6.3.9.2 Check probe height (kit only) 25
7 Printing 26
7.1 Removing objects from the printer. 26
7.2 Printer Control 27
7.2.1 LCD screen 27
7.2.2 Controlling the LCD screen 27
7.2.3 Print statistics 28
7.2.4 Fail stats 29
7.2.5 Normal vs. Stealth mode 29
7.2.6 Factory reset 29
7.2.7 SD card sorting 30
7.2.8 Testing if file (.gcode) is complete 30
7.2.9 LCD layout 31
7.2.10 Print speed versus print quality 33
7.2.11 USB cable and Pronterface 33
7.2.12 Power panic 35
7.3 Printer addons 36
7.3.1 Different nozzles 36
7.3.1.1 Hardened steel nozzle 36
7.3.1.2 0.25mm nozzle 36
7.3.2 Connecting Raspberry Pi Zero W 37
4
To Next Page
Loading...
