Page: 6
5.3 Wireless Device Control?
This function learns or deletes all wireless inputs and bells to the Euro 46 APP Panel, if you have a
wireless ZEM installed (EURO-ZEM32-WE).
NOTE: The keyfobs are learned and programmed from the Master Manager menu.
5.3.1 Control Inputs?
Learn Devices?
This menu starts the procedure of learning wireless inputs onto the Euro 46 APP Panel.
Input
This menu chooses which input on the system is to be learned. ‘Learnt’ will be displayed if a device
is already learnt, or ‘Available’ will be displayed if it is not.
Input
Learning…
1) Open the wireless device.
2) Remove the plastic insulation to enable the battery.
3) If a device is not learned = The GREEN and RED LEDs on the device will flash (alternating).
4) Press and hold the ‘LEARN’ button on the device = The three LEDs start cycling around.
5) Release the ‘LEARN’ button = ‘Input Learnt’ will be displayed and a confirmation tone will be
emitted by the panel.
6) If an input has already been learnt, ‘Input learnt already’ will be displayed.
Example: The image below shows how to learn an MC detector. Please note all other wireless
peripherals are learned the same way.
5.3.2 Delete Devices?
Already learnt inputs may be deleted from this menu.
Delete All
Enter Code
To delete all wireless input devices enter ‘2000’ (this is the Panel Security Code). ‘Please wait’ will
be displayed while the Euro 46 APP Panel deletes ALL the learnt wireless inputs.
Choose Input to Delete
This option deletes only a specific wireless device learnt to an input. Any inputs that display ‘learnt’
can be deleted. ‘Please wait’ will be displayed while the Panel deletes the wireless device. Return to
this process to delete more devices.
5.3.3 Control Bells?
Learn Devices?
Entering this menu allows the learning of wireless bells onto the system.
Select Bell
Selects the bell on the system that is to be learnt. ‘Learnt’ will be displayed if a bell is already
learnt, or ‘Available’ will be displayed if not.
LEARN
>5s
To Next Page
Loading...
Need help?
General
