Pyronix Vocaliser - Input 4 (Dial Abort Option )

VOCALISER INSTALLATION MANUAL
RINS119-5 Page: 13
¾ Dial  to change input 3.
¾ “THREE” will be heard.
¾ Enter the trigger type:
o Dial  for Negative Applied (default) or
o Dial  for Positive Removed or
o Dial # for Negative Removed or
o Dial  for Positive Applied
¾ “ SAVED” will be heard.
¾ “ PLEASE ENTER COMMAND” will be heard
returning you to the engineer menu.
¾ Dial  to change input 4.
¾ “FOUR” will be heard.
¾ Enter the trigger type:
o Dial  for Negative Applied (default) or
o Dial  for Positive Removed or
o Dial # for Negative Removed or
o Dial  for Positive Applied
¾ “ SAVED” will be heard.
¾ “ PLEASE ENTER COMMAND” will be heard
returning you to the engineer menu.
6.2 Input 4 (Dial Abort Option)
Input 4 on the Vocaliser may be programmed to be an input which will abort the dial sequence.
If this is enabled, the Vocaliser will abort the dialling sequence if there is a change in the state
of Input 4 (a voltage change).
¾ Dial  to program input 4.
¾ A “BEEP” will be heard
¾ Enter either of the following:
o Dial  to set the input as an alarm type.
o “INPUT FOR ALARM SAVED” will be heard.
or
o Dial  to set the input as an abort type
o “INPUT FOR ABORT SAVED” will be heard.
¾ “PLEASE ENTER COMMAND” will then be heard
returning you to the engineer menu.