VOCALISER INSTALLATION MANUAL
RINS119-5 Page: 21
CHAPTER 8: THE VOCALISER LOG
8.1 Reading the Log
The log records everything about the Vocaliser’s operation and gives you useful information as
to why a call hasn’t gone through or if there are any problems with the telephone line.
The log is read by first the telephone number, then a code which is defined below:
0 = Acknowledge
1 = Voice plus no acknowledgement
2 = Engaged
3 = Ring no answer
4 = Unobtainable
5 = No dial tone
6 = PSTN problems – Telephone network problems
7 = PSTN problems – Telephone network problems
8 = Wrong user code entered
9 = Good user code entered (counts as an acknowledge if required)
To scroll through the log:
= Will go backwards
=Will go forwards
P = Will exit.
¾ Dial #to read the log
¾ The codes will be heard.
¾ Press P to exit.
¾ “PLEASE ENTER COMMAND” will be heard
returning you to the user menu
¾ For example, if the log says: “TELEPHONE
NUMBER 1, CODE, 5”.
¾ Telephone number one could not dial due to no
dial tone.
8.2 Clearing The Log
To erase the entire Vocaliser log:
¾ Dial to clear the log
¾ “SAVED” will be heard
¾ “PLEASE ENTER COMMAND” will be heard
returning you to the user menu
“NOT SAVED” will be heard if the engineer has
disabled access to users to clear the log.
To Next Page
Loading...
