Q-See QT SERIES Manual

36
Setting the Motion Detection Recording Schedule
A. Select Record Schedule in the Record tile.
ATTENTION: Your system is factory-set
to record whenever motion is detected at
any time. These instructions are to help
you set a specific schedule.
Add Camera Edit Camera
Image Settings Motion PTZ
Camera
TCP/IPv4 DDNS Port E-mail
Network Status
Network
Basic Date and Time Information
View Log Backup and Restore
Disk Management Storage Mode
System
Add User Edit User
Edit Permission Group
Modify Password
Account and Authority
Encode Parameters
Record Schedule Advanced
Record
Sensor Alarm Alarm-Out
Motion Alarm
Alarm
To schedule ALL cameras
B. Select Edit in the Motion Detection Schedule pull down.
Live Display
Mode Settings
Camera Name
Sensor Record Schedule Motion Record Schedule
Timed Record Schedule
Cam1
Cam2
Cam3
Cam4
Cam5
Cam6
AdvancedSchedule Config
Camera Record
Alarm Network Account
Edit
Edit Schedule
Motion
Manual All Reverse Clear All
CancelOK
Manual All Reverse Clear All
00:00 ~ 24:00
Sun 0 2 4 6 8 10 12 14 16 18 20 22 24
Manual All Reverse Clear All
00:00 ~ 24:00
Mon 0 2 4 6 8 10 12 14 16 18 20 22 24
Manual All Reverse Clear All
00:00 ~ 24:00
Tues 0 2 4 6 8 10 12 14 16 18 20 22 24
Manual All Reverse Clear All
00:00 ~ 24:00
Wed 0 2 4 6 8 10 12 14 16 18 20 22 24
Manual All Reverse Clear All
00:00 ~ 24:00
Thur 0 2 4 6 8 10 12 14 16 18 20 22 24
Manual All Reverse Clear All
00:00 ~ 24:00
Fri
0 2 4 6 8 10 12 14 16 18 20 22 24
Manual All Reverse Clear All
00:00 ~ 24:00
Sat
0 2 4 6 8 10 12 14 16 18 20 22 24
C. Select All to fill in the entire schedule area.

Q-See QT SERIES Specifications

General

Series	QT Series
Video Compression	H.264
Remote Viewing	Yes
HDMI Output	Yes
VGA Output	Yes
Motion Detection	Yes
Channels	4, 8, 16
Recording Resolution	1080p, 720p
Hard Drive Capacity	Up to 6TB
Mobile App Support	Yes
Network Connectivity	Ethernet