11
Beep Alarm (beep alarm can be disabled in “System Tools” > “Hardware
Settings”)
Beep sound No. of Times
Description
Short beep (0.5 sec) 1 1) The NAS is starting up
2) The NAS is being shut down
(software shutdown)
3) The user presses the reset button to
reset the NAS
4) The system firmware has been
updated
Short beep (0.5 sec) 3 The NAS data fails to be copied to the
external storage device from the front
USB port
Short beep (0.5 sec),
long beep (1.5 sec)
3, every 5 min
The system fan is out of function*
2 1) The disk volume is going to be full
2) The disk volume has reached its full
capacity
3) The hard drives on the NAS are in
degraded mode
4) The user starts the HDD rebuilding
process
Long beep (1.5 sec)
1 1) The NAS is turned off by force
shutdown (hardware shutdown)
2) The NAS has been turned on
successfully and is ready
* This function is applicable to some models only. Please refer to the comparison
table for more details:
http://www.qnap.com/images/products/compa
rison/Comparison_NAS.html
To Next Page
Loading...
