131
4. Configure your NAT router (for remote monitoring over the Internet)
To view the monitoring video and connect to the NAS remotely, you need to change
the network settings by forwarding different ports to the corresponding LAN IP on
your NAT router.
Change the port settings of the NAS and the IP cameras
The default HTTP port of NAS is 8080. In this example, the port is changed to 8000.
Therefore, you have to connect to the NAS via http://NAS IP:8000 after
applying the settings.
Then login the network settings page of the IP cameras. Change the HTTP port of
the IP camera 1 from 80 to 81. Then change the port of the IP camera 2 from 80
to 82.