QUANTA QuantaGrid S31A-1U - Page 104

BMC CONFIGURATION GROUP
3-46
Procedure:
1. In the Alert Policy Tab, select the slot for which you have to configure the Alert pol-
icy. That is, In the Event Filter Entry Page, if you have chosen Alert Policy number
as 4, you have to configure the 4th slot (the slot with Policy Number 4) in the Alert
Policy Tab.
2. Double click the slot and click Add to open the Add Alert Policy Entry Page as
shown in the screenshot below.
Figure 3-28. Add Alert Policy Entry Page
Table 17: PEF Management - Alert Policy
ITEM DESCRIPTION
Policy Entry #
Displays Policy entry number for the newly configured entry (read-
only).
Policy Number Displays the Policy number of the configuration.
Policy Configuration To enable or disable the policy settings.
Policy Set
To choose any one of the Policy set values from the list.
 0: Always send alert to this destination.
 1: If alert to previous destination was successful, do not send alert to
this destination. Proceed to next entry in this policy set.
 2: If alert to previous destination was successful, do not send alert to
this destination. Do not process any more entries in this policy set.
 3: If alert to previous destination was successful, do not send alert to
this destination. Proceed to next entry in this policy set that is to a
different channel.
 4: If alert to previous destination was successful, do not send alert to
this destination. Proceed to next entry in this policy set that is to a
different destination type.
Channel Number To choose a particular channel from the available channel list.
Destination Selector
To choose a particular destination from the configured destination list.
Note:
LAN Destination has to be configured - under Configuration -> PEF ->
LAN Destination.
Modify To modify the existing entries.
Delete To delete Alert Policy list.