BMC FIRMWARE UPDATE
3-92
Preserve Status: The status of the Preserve Configuration items.
Procedure
1. To proceed HPM Firmware Update, click Continue. The Firmware update undergoes
the following steps:
a. Click Choose File to browse and select the Firmware image to flash and click Ok.
While creating HPM image with multiple components, Boot and App compo-
nents should be placed at the end of the conf file.
b. Preparing Device for Firmware Upgrade.
c. Uploading Firmware Image.
d. If flashing is required for all Components, select the option Update All to update
all the Components or select any specific Component Name and click Proceed
to update the Firmware. The list of components used to allow you to configure
the Firmware image will be displayed as shown in the below screenshot.
e. Flashing the image.
f. Resetting the image. The sample screenshot of HPM Firmware update is as
shown below.
You will not be able to perform any other tasks until firmware upgrade is com-
pleted and the device is rebooted. You can now follow the instructions pre-
sented in the subsequent pages to successfully update the card’s firmware.
The device will reset if update is canceled. The device will also reset upon
successful completion of firmware update.
To Next Page
Loading...
Need help?
General
