Quantech QWC3050T-200T

FORM QWC3-NM1
ISSUE DATE: 11/20/2020
SECTION 9 – SERVICE AND TROUBLESHOOTING
QUANTECH
162
PRINTING A REPORT
After pressing the PRINT key, press the ◄ or ► key
until the desired printout is displayed. The available
printout types are listed in Table 25 on page 162.
TABLE 25 - PRINTOUT TYPES
PRINTOUT TYPES
Operating Data (Default)
All History Bu󰀨ers
Normal Shutdowns
History Bu󰀨er 1
History Bu󰀨er 2
History Bu󰀨er 3
History Bu󰀨er 4
History Bu󰀨er 5
History Bu󰀨er 6
History Bu󰀨er 7
History Bu󰀨er 8
History Bu󰀨er 9
History Bu󰀨er 10
Cancel Printing
Press the  key to initiate the printout.
When OPERATING DATA is selected, the data at that
instant will be temporarily stored in memory, and then
transmitted through the print port. HISTORY BUFFER
data is captured at the instant of that particular fault,
and the selected buffer data is then transmitted through
the print port.
Bold italic text below a line of print is not
on the actual printout. It indicates infor-
mation that may not be available on all
printouts, or is additional information to
help explain the difference in a two -
circuit printout.