Communication Protocol CubiScan 25 Command Set
CubiScan 25 Service Manual 64
Key Coordinates
This command causes the CubiScan 25 to accept keyboard input in touch pad coordinates. The X
coordinate is horizontal, the Y coordinate is vertical.
Location Identification
This command is used to set the CubiScan 25 location identification. The location identification
is a six-digit code which uniquely identifies the CubiScan 25 within the user’s operation. This
location identification is included in each measurement packet. This data is stored in permanent
memory and need only be set once for each CubiScan 25.
Pos Len Description Type Range ASCII
Command Format
1 1 Start of Text Control (STX) 02h
21Key Command Alpha (k) 6Bh
3 4 X Coordinate Numeric 0000-9999
7 1 Comma Alpha (,) 2Ch
8 4 Y Coordinate Numeric 0000-9999
12 1 End of Text Control (ETX) 03h
13 1 Carriage Return Control (CR) 0Dh
14 1 Line Feed Control (LF) 0Ah
Acknowledge Format
1 1 Start of Text Control (STX) 02h
21Key Command Alpha (k) 6Bh
3 1 Acknowledge Alpha (A) 41h
41End of Text Control(ETX) 03h
5 1 Carriage Return Control (CR) 0Dh
61Line Feed Control(LF) 0Ah
Negative Acknowledge Format
1 1 Start of Text Control (STX) 02h
21Key Command Alpha (k) 6Bh
31Neg. Acknowledge Alpha (N) 4Eh
41End of Text Control(ETX) 03h
5 1 Carriage Return Control (CR) 0Dh
61Line Feed Control(LF) 0Ah
Pos Len Description Type Range ASCII
Command Format
1 1 Start of Text Control (STX) 02h
To Next Page
Loading...
Need help?
General
