www.qutools.com quTAG MC Manual 7
2.3 Environmental Conditions
Warning. Operation outside the following environmental limits may
adversely affect operator safety:
• Indoor use only
• Maximum altitude 2000 m
• Temperature range 5°C to 40°C
• Maximum humidity less than 80% RH (non-condensing) at 31°C
• To ensure reliable operation the unit should not be exposed to
corrosive agents or excessive moisture, heat or dust. If the unit has
been stored at a low temperature or in an environment of high
humidity, it must be allowed to reach ambient conditions before
being powered up.
2.4 Electrical Installation
The unit must be connected only to an earthed fused supply of 100 to 240V
(Japan, USA and Europe).
Use only power supply cables supplied by the manufacturer, other cables
may not be rated to the same current. The unit is shipped with appropriate
power cables for use in Europe. When shipped to other territories the
appropriate power plug must be fitted by the user.
Never connect any cabling to the electronics when contacts are exposed!
Avoid short-cuts.
Prevent electrical shock from electronic. To prevent electrical shock do not
remove the cover of the control unit. Unplug power cord and all other
electrical connections and consult qualified service personnel when
servicing or cleaning. Operate only under dry conditions and at room
temperature conditions.
2.5 Preventive Maintenance
The equipment contains no user serviceable parts. There is a risk of severe
electrical shock if the equipment is operated with the covers removed. Only
personnel authorized by the vendor and trained in the maintenance of this
equipment should remove its covers or attempt any repairs or adjustments.
Maintenance is limited to safety testing and cleaning as described in the
following sections.
To Next Page
Loading...