appears. After about 2 seconds, the scanner
starts searching. When the scanner fi nds
an active frequency, it stops searching and
displays the frequency’s number.
• To reverse the search direction at any
• To pause searching frequencies, press
. PSE appears. To resume searching,
• If necessary, you can select search groups
To search for another active frequency in the
an active frequency within a sub-band of the
fi re/police or ham band, press a number key
to select the sub-band you want. To select a
different band and search for another active
frequency, repeat Step 1.
You can set Zeromatic on or off by pressing
the Zeromatic setting. Whenever this feature is
turned on, — — appears at the both sides of the
when the scanner stays tune mode) and
the scanner stops at the correct frequency. When
you turn this feature off, — — disappears and the
scanner stops when it detects an active signal.
Zeromatic functions only in Police/Fire, Aircraft,
Amateur band, and tune operation.
In the aircraft band, press
start searching up from the lowest frequency or
to start searching down from the highest
To Next Page
Loading...
