RadioMaster MT12

2.6. Switch and Joysck Expansion Modules
The MT12 features interchangeable expansion modules and includes a two 2 posions switch module and a 4 way
Joysck module. You can choose the module you wish to install based on your own preferences.
Hardware Installaon
Two 2 Posion switch module:
4 way Joysck module:
Soware Setup
Two 2 Posion Switch module:
For the two 2 Posion switch plate, press the SYS buon and then Page > buon to reach the HARDWARE page.
Using the roller scroll down to S3 and S4. Set both S3 and S4 to “Switch”. Next, scroll down to FL1 and FL2. Set FL1 to
S3 and choose “2POS”. Set FL2 to S4 and choose “2POS”.
4 Way Joysck module:
For the 4 way Joysck plate, press the SYS buon and then Page > buon to reach the HARDWARE page. Using the
roller scroll down to S3 and S4. Set S3 to Axis X and set S4 to Axis Y. Once this is set, please enter the calibraons
screen and do a calibraon (as you would for the wheel, trigger and knobs). Please note, at the me of wring this
manual there is no visual display of the 4 way joy sck movement when calibrang, however the calibraons is taking
please. Please move the 4 way joysck across both axis and complete the calibraon.