RadioMaster MT12

3.4. Reversing a Servo
To change the direcon of a servo movement, press the [MDL] buon. Press [Page>] unl you reach the “OUTPUTS”
screen. Select the channel that you wish to reverse the servo out put on with the roller. Press enter and select “Edit”.
Use the roller to scroll to “Direcon” and select “INV”. The servo output is now reversed from its standard output.
3.5. EXPO
To set EXPO on a channel, press the [MDL] buon then press [Page>] unl you reach the “INPUTS”. User the roller to
select the channel you wish to add EXPO to. Press enter and select “Edit” and use the roller to select Expo. Enter the
desired amount of Expo required, in the example below, 25 points of Expo has been entered. Exit from this screen
and “E25” will show conrming this channel now has 25 points of Expo set.
3.6. Dual Rates
To set up a dual rate on a switch press the [MDL] Buon and then press [Page>] unl you reach the you reach the
“INPUTS” screen. On the Channel you wish to set a dual rate on press and hold enter on the roller buon and choose
“Insert before”. In this example we will setup a Dual rate on the SA switch with a rate of 60% and 80% on the “ST” aka
steering channel. First select the “Weight” Opon and enter the amount of rate you desire, in the example below we
will set 60%. Then scroll to “Switch” and press enter to select a switch then move the SA switch in to the rst
posion. Press [RTN] to exit. Repeat the process on the 2
nd
line of the “ST” channel in the “INPUTS” screen and enter
a weight, in this case we will enter 80%. Select the posion of the SA switch for the 2
nd
rate. Press [RTN] when done.
You will now have dual rates of 60% and 80%. You may also add expo to both rates with the method above.
You may also add expo to both rates with the method above in secon 3.5.