RadioMaster MT12

RX Status
Rqly Poron of Telemetry screen
Here you can congure the threshold for the RX alarms. The Rx-Stats label will change (Rx-Stats, RSSI, Rqly,
Sgnl) depending on the protocol that is used with the model.
• Low alarm - The threshold value when the "RF signal low" voice prompt will be played. The recommended
value is 45.
• Crical alarm - The threshold value when the "RF signal crical" voice prompt will be played. The
recommended value is 42.
• Disable telemetry alarms - When enabled, no alarm voice prompts will be played.
Variometer
A variometer detects changes in the model altude. EdgeTX can alert the user of these altude changes by
providing a rising/lower pitched tone. Use the Variometer menu on the Radio Setup page to set the actual
frequency and volume of the tone to be played. The following opons exist to congure the variometer
alarm.
You will need to use a Vario Special or Global Funcon to enable this funconality!
• Source - Species the sensor to use as the variometer. It is selected from the telemetry sensors added in
Sensors secon.
• Range - Species the ascent/descent range that will trigger the change in the Variometer beeping pitch. If
climb/descent rate is within the range specied here, beeping pitch will change according to that value.
When it goes beyond the range specied here, beeping pitch will stop changing. Units are meters/second or
feet/second based on the Units seng on the Radio Setup page.
• Centre - Specify the range for ignoring changes in climb/descent rates. When the climb/descent rate is within
the range specied here, the beeping pitch will not change.
• Tone/Silent - Species whether to beep when climb/descent rate is within the range specied by Centre.
8.2. Sensor Conguraon
Sensor Conguraon page
The below opons can be congured for sensors:
• Name: Name of the sensor - up to 4 characters.