ASSEMBLY
OM 0495SB-A [12]
SNOWBLOWER ASSEMBLY
The snowblower is assembled at the factory, however, the chute must be assembled and installed. Before
proceeding with assembly, separate all hardware according to their dimensions. When assembly is
complete, and unless otherwise specified, tighten all bolts referring to the torque table located at the end of
the manual.
TRACTOR PREPARATION
If applicable, remove the lawn mower from the tractor and front loader following the instructions in the tractor
owner's manual.
IMPORTANT: The front loader and the subframe must never be installed simultaneously on the tractor.
LUBRICATION: Use a high-quality grease designated "extreme pressure" and containing molybdenum
disulphide. This grease may specify "Moly EP" on its label.
To avoid serious personal injury or
death:
Read and understand SAFETY
INFORMATION on previous pages before
installation and operation Perform all
assembly with the assembly properly
secured and supported.
To avoid serious personal injury or
death:
Park the vehicle on level ground, place the
transmission in neutral, set the parking
brake, place all control levers in neutral,
shut off the engine, remove the ignition key
and allow the rotating parts to stop BEFORE
starting installation on the tractor.
To Next Page
Loading...