STORAGE
OM 0495SB-A [43]
STORAGE
(Figures A-B)
Before storing the snowblower, certain
precautions should be taken to protect it from
deterioration.
1. Clean the snowblower and hitches
thoroughly.
2. Make all the necessary repairs.
3. Replace any safety decals that are damaged,
lost, or no longer legible. If a part that needs to
be replaced requires a safety decal, obtain a
new one from your dealer and place it in the
same location as the original part.
4. Paint any parts that are worn or chipped.
5. Lubricate the snowblower as instructed in the
“Lubrication” section.
6. When the snowblower is dry, oil the moving
parts. Liberally oil all surfaces to prevent
rusting.
7. Figure A: Insert each of the ø1" x 3 7/8" pins
(item 1) in the hole (item 2) on each side of the
snowblower frame.
8. Figure A: Insert each of the ø1/4" round
locking pins (item 3) in the hole (item 4) on
each side of the snowblower frame.
9. Figure A: Remove the male driveline (item 5)
from the drive system on top of the 4-pt hitch.
10. Figure B: Wind the hydraulic hoses and the
electric harness around the chute.
11. Store in a dry place.
To Next Page
Loading...