OPERATION
OM 0495SB-A [33]
PREPARATIONS
1. Read the operator's manual carefully before
using the tractor and snowblower. Be very
familiar with the control systems and the
proper use of the equipment. Know how to
stop units and disengage control units quickly.
2. Wear adequate winter clothing when using the
equipment.
3. Make sure the snowblower is cleared of snow
and free of all material before starting the drive
mechanism.
4. Make sure the auger and fan are free of
obstructions and turn freely.
5. Check the oil level in the reduction box and, if
necessary, add SAE 80W90, AGMA 5EP gear
oil or equivalent.
6. Check the 3 shear bolts, one on each auger
section and on the fan, for proper tightness.
7. Adjust the skid shoes to level so that they slide
properly.
8. Start the tractor and idle the tractor BEFORE
engaging the snowblower.
9. Operate the snowblower at maximum speed.
CAUTION: To avoid serious injury:
Never use your hands to unblock the chute .
Use a 36 "(925mm) long stick or plank. Do not
attempt to clear a chute blocked with snow
when the engine is running. If the chute jams,
stop the tractor engine, remove the ignition
key and then clear the chute.
WARNING: To avoid serious injury or
death:
• Do not allow people to stay near the work
area.
• Do not allow anyone to climb on the
equipment or the quick hitch.
• Before cleaning, adjusting or repairing the
equipment, bring the tractor to a complete
stop, wait for all moving parts to stop, apply
the brakes, lower the equipment to the
ground, switch off the engine and remove the
ignition key.
• Do not place any part of your body under the
equipment during adjustments.
WARNING
Always operate the equipment from the
operator's seat. Never allow anyone to climb
on the machine.
WARNING
Operate the equipment at a speed that
matches the working conditions. Be very
careful when working near an embankment or
on uneven ground.
WARNING
Always wear safety glasses when using any
equipment.
To Next Page
Loading...