EasyManua.ls Logo

RadTech S1SB-54A - Troubleshooting

Default Icon
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TROUBLESHOOTING
OM 0495SB-A [42]
PROBLEM
CORRECTIVE MEASURES
1. Auger and fan not
turning
Check if an object is blocking the auger or fan
Check that PTO is engaged
Check that the drive system is in the engaged position
Check if chain is broken
Check if shearbolts are broken and replace if necessary
Gearbox lacking oil and is seized. Replace gearbox.
2. Snow is not being
ejected from the chute
Check if the fan is turning, refer to problem # 1
Check if the snow output is obstructed, unclog with a 36" stick
3. Snowblower clogs up
easily
Engine is not at full RPM
Check that the chute is not obstructed
Reduce travel speed
4. Snow doesn't enter the
snowblower properly
Engine is not at full RPM
Check if shearbolts are broken and replace if necessary
Check auger positions. (refer to section Operation)
5. Snow is not thrown very
far
Engine is not at full RPM
Reduce travel speed
Check that the chute is not obstructed
6. Snowblower will not
connect to the hitch
Check that the connection system is not obstructed
Make sure that the pins of the snowblower hitch are removed.
Make sure that the snowblower driveline is on its support.