OPERATION
OM 0495SB-A [35]
ADJUSTMENTS
CAUTION: To avoid serious injury or
death: Make sure the engine and all
equipment components are completely
stopped, and the drive mechanism is
turned off BEFORE making any
adjustments.
Adjustment of the Deflector
The angle of the deflector must be adjusted so
that the snow is sent to the correct distance.
• To adjust the angle of the deflector UP, pull the
switch back.
• To adjust the angle of the deflector DOWN,
push the switch forward
Adjustment of the skid shoes
Adjust the snowblower so that the skid shoes
slide level with the ground and take into account
the terrain conditions, so that the snowblower
does not send back gravel or rocks with the snow.
Make sure they are at the same height so that the
cutting edge is leveled.
To adjust the skid shoe (item 1), remove the
ø3/8 "NC hex nut (item 2), lock washer (item 3),
flat washer (item 4) and the ø3/8"NC x 1 3/4"
carriage bolt (item 5). Secure with the hardware
(items 2-3-4-5) in the appropriate hole according
to the following settings.
Distance between the cutting edge and the
ground surface:
At level paved surface:
1st adjustment - the bottom hole of the skid shoe
in the bottom hole of the frame.
2nd adjustment - from the center of the skid shoe
into the hole on the top of the frame.
Uneven surface or gravel:
1st adjustment - from the center of the skid shoe
into the hole in the bottom of the frame.
2nd adjustment - from the top of the skid shoe into
the hole on the top of the frame.
To Next Page
Loading...