ESP-SMT Smart Modular Control System
40
Fine Tune Watering By Zone
This section shows you how to make quick, minor adjustments (+/- 60%) to
each zone’s run-time calculation based on changing weather patterns and the
site/zone parameters previously entered.
Rotate the dial to FINE TUNE WATERING position...
A
The FINE TUNE BY ZONE screen will
appear and the value for Zone 1 will
begin to blink.
B
IIf you want to ne-tune the irrigation
amount applied to Zone 1, press either
the - or + button(s) until the desired value
is displayed. Press the NEXT button and
the value for zone 2 will begin to blink.
C
Continue to press the NEXT button to
advance to the next Zone you would
like to Fine Tune. Press either the - or
+ button(s) to adjust the value. Once
the desired value is displayed, press the
NEXT button and the value for the next
sequential Zone will begin to blink.
!
NOTE: After making all of the Fine
Tune By Zone adjustments, move the
dial into the AUTO position. These
adjustments will occur indefinitely
until you rotate the dial into the FINE
TUNE WATERING position and make
additional adjustments.
C
B
A
FINE TUNE BY ZONE
1061 +0
+0 +0
+0
+0 n/a
n/a
n/a
n/a
n/a
n/a
+0
+0
1172
1283
1394
5
% %
% %
%
%
%
NEXTBACK
FINE TUNE BY ZONE
61 +12
+0
+0
+0
+0
72
83
94
5
%
%
%
%
%
NEXTBACK
10
+0
+0
n/a
n/a
n/a
n/a
n/a
n/a
11
12
13
%
%
FINE TUNE BY ZONE
61 +12
+0
+0
+14
-8
72
83
94
5
%
%
%
%
%
NEXTBACK
10
-11
+0
n/a
n/a
n/a
n/a
n/a
n/a
11
12
13
%
%
FINE-TUNE
WATERING
SET DATE
& TIME
AUTO
SPECIAL
FEATURES
SYSTEM
REVIEW
INPUT ZONE
INFORMATION
CONFIGURE
CONTROLLER
MANUAL
WATERING
OFF
RESTORE
SETTINGS
To Next Page
Loading...
Need help?
General
