Raisecom iTN8600-I - Table 4-4 Concentration Requirements for the Mechanical Active Substance in Storage; Table 4-5 Concentration Requirements for the Chemical Active Substance in Storage

Raisecom
iTN8600-I (A) Product Description
4 Technical specifications
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
27
Waterproof requirements
Generally, the iTN8600-I should be installed indoor.
Ensure that there is no impounded water on the ground and avoid any liquid leakage on the
device. Put the iTN8600-I away from the automatic fire-fighting facility and heating plants,
etc.
If the iTN8600-I is installed outdoor, you need to ensure the following matters:

The packing case is intact.

Take measurements to prevent water from entering the packing case.

There is no ponding on the ground.

No direct sunlight on the packing box
Biotic environment
Keep the iTN8600-I away from:

Microorganism, such as fungus and mould

Rodent animals, such as rats
Air cleanliness
There should not be any explosive, electro-conductive, magneto-conductive, or corrosive
substance.
Table 4-4 lists concentration requirements for the mechanical active substance in storage.
Table 4-4 Concentration requirements for the mechanical active substance in storage
Mechanical active substance
Concentration
Suspending dust (mg/m³)
≤ 5.00
Droppable dust (mg/m²·h)
≤ 20.0
Grit (mg/m³)
≤ 300
Table 4-5 lists concentration requirements for the chemical active substance in storage.
Table 4-5 Concentration requirements for the chemical active substance in storage
Chemical active substance
Concentration
SO
2
(mg/m³)
≤ 0.30
H
2
S (mg/m³)
≤ 0.10
NO
2
(mg/m³)
≤ 0.50
NH
3
(mg/m³)
≤ 1.00
Cl
2
(mg/m³)
≤ 0.10