R&S ESU Remote Control – Description of Commands
Introduction
6.4 Operating Manual 1302.6163.12 - 03
6.1 Introduction
This chapter describes all remote control commands of the R&S ESU in detail. For details on the nota-
tion of the remote control commands refer to “Notation” on page 6.5.
Before sending a command sequence consisting of commands described in chapter 6, please make
sure that the analyzer mode is active, by one of the following actions:
• Set the preset compatibility to the analyzer mode (SYST:PRES:COMP FSP command).
• Perform a preset (*RST).
•Use the INST:SEL SAN command.
The remote control commands are sorted according to the subsystem they belong to. The following
subsystems are included in this chapter:
• “Common Commands” on page 6.8
• “ABORt Subsystem” on page 6.11
• “CALCulate Subsystem” on page 6.12
• “CALibration Subsystem” on page 6.98
• “DIAGnostic Subsystem” on page 6.100
• “DISPlay Subsystem” on page 6.104
• “FORMat Subsystem” on page 6.114
• “HCOPy Subsystem” on page 6.115
• “INITiate Subsystem” on page 6.125
• “INPut Subsystem” on page 6.129
• “INSTrument Subsystem” on page 6.134
• “MMEMory Subsystem” on page 6.138
• “OUTPut Subsystem” on page 6.151
• “SENSe Subsystem” on page 6.152
• “SOURce Subsystem” on page 6.220
• “STATus Subsystem” on page 6.226
• “SYSTem Subsystem” on page 6.235
• “TRACe Subsystem” on page 6.246
• “TRIGger Subsystem” on page 6.260
• “UNIT Subsystem” on page 6.262
An alphabetical list of all remote commands is provided at the end of this chapter in section “Alphabetical
List of Remote Commands” on page 6.336. Additionally, a subset of remote commands of HP models is
supported. These commands are listed in section “GPIB Commands of HP Models 856xE, 8566A/B,
8568A/B and 8594E” on page 6.263.
For information on differences between the FSP and FSE families refer to section “Differences in GPIB
Behavior between the FSP and the FSE Families of Instruments” on page 6.289.
To Next Page
Loading...
