R&S SM300 - Page 31

R&S SM300 Installation of Software Updates and Drivers
Version 04 31
Service Manual SM300: 1147.1652.00 Instrument Part No SM300: 1147.1498.03
The following figures show an update of the SM300 generator module
and the power supply and a subsequent pop-up menu of the application.
Caution
Do not switch off the device while the system is being updated if there is no
prompt from the Series 300 Software Manager application. After the file is
selected, the devices included in the .out file will automatically be updated.
Module software cannot be updated with a new version if not supported.
During the update of the SM300 module, the standard remote control
screen will appear on the MMI. During the update of the power supply, no
LEDs on the front panel of the R&S SM300 will light up, and the R&S
SM300 will appear to be switched off. Please observe the update status on
the external PC to make sure that the system is still running.
It might be necessary to install the USB drivers again during the update
process.
Module update
Driver installation
Caution
It might be necessary to install the power supply USB driver (rssi.sys) again
during the update process. This must be done during a time interval of
approx. 1 minute, otherwise the update of the power supply module will fail
and the complete update needs to be restarted again.
Please carry out the instructions described in chapter “Installing the Device
Drivers” again (see Section
1.2.1).