R&S SM300 - Page 32

Installation of Software Updates and Drivers R&S SM300
Version 04 32
Service Manual SM300: 1147.1652.00 Instrument Part No SM300: 1147.1498.03
Update of the SM300
generator module
and the power supply
and a subsequent
pop-up menu of the
application
After switching on the instrument for the first time after a successful
firmware update, the following system message might occur once:
SYSTEM-MESSAGES: dd/mm/yy hh:mm PS ERROR 0x6011: Parameter
0x000000C0 and 0x00
MMI Error windows (red popup): PS 0x6011
In this case the unit needs to be switched off and on again. This system
message does not appear again during further power-on cycles.

Note
Successful updates are indicated with a tick ().Failed updates are
indicated with a cross (x). Should any of the updates fail to install, please
retry until they are successful.
failed
successful