R&S ZNLE Series - Page 569

Command reference
R&S
®
ZNL/ZNLE
569User Manual 1178.5966.02 ─ 20
INSTrument:CREate[:NEW] <ChannelType>, <ChannelName>
This command adds a measurement channel. You can configure up to 10 measure-
ment channels at the same time (depending on available memory).
See also
●
INSTrument[:SELect] on page 571
●
INSTrument:DELete on page 569
Parameters:
<ChannelType> Channel type of the new channel.
For a list of available channel types, see INSTrument:LIST?
on page 570.
<ChannelName> String containing the name of the channel.
Note that you cannot assign an existing channel name to a new
channel. If you do, an error occurs.
Example:
INST:CRE SAN, 'Spectrum 2'
Adds a spectrum display named "Spectrum 2".
Manual operation: See " New Channel Setup " on page 88
INSTrument:CREate:REPLace <ChannelName1>,<ChannelType>,<ChannelName2>
This command replaces a channel setup with another one.
Setting parameters:
<ChannelName1> String containing the name of the channel setup you want to
replace.
<ChannelType> Channel type of the new channel setup.
For a list of available channel setup types, see INSTrument:
LIST? on page 570.
<ChannelName2> String containing the name of the new channel setup.
Note: If the specified name for a new channel setup already
exists, the default name, extended by a sequential number, is
used for the new channel setup (see INSTrument:LIST?
on page 570).
Channel names can have a maximum of 31 characters, and
must be compatible with the Windows conventions for file
names. In particular, they must not contain special characters
such as ":", "*", "?".
Usage: Setting only
Manual operation: See " Replace Current Channel Setup " on page 89
INSTrument:DELete <ChannelName>
This command deletes a channel setup.
Common instrument commands