Self test is an automatic and mandatory program, which must be executed aer first time switching on the unit.
Self test needs approximately 45 minutes for units 61 - 102 or 60 minutes for units 201 - 202. This time will be
extended automatically by 20 minutes in case a UltraVent is connected to the unit.
Make sure the water is connected and the water tap is open (test at hand shower).
To start the self test the unit must be below 40°C (104°F) and a flat and closed GN container must be inserted in
the middle of the fan wheel (units 201 - 202: 2x GN Container) in order to achieve the best humidity calibration
results.
SCC Index H-I:
When prompted to select water connection choose normal water. So water can always be selected later in Basic
settings in case the unit develops too much foam when in CleanJet mode.
CM_P:
Insert the GN container same as above.
Close the door and press the Prog/Start key.
Self test done correctly
- 37 - V07 en, Basic_Installation_Accessories
US/Canada 12/2018
To Next Page
Loading...
