Important Information i
Important Information
Intended use
This handbook provides information and instructions to assist in planning and
installing your Raymarine C-Series Display, together with information that will be
useful when you are connecting the C-Series Display to other equipment.
In order to obtain the best results in operation and performance, please read this
handbook thoroughly.
Safety notices
WARNING:Navigation aid
This product is intended to be used as an aid to navigation. Its
accuracy can be affected by many factors, including
equipment failure or defect, environmental conditions and
incorrect handling or use. It is the Users responsibility to
exercise common prudence and navigational judgement. This
device should not be relied upon as a substitute for such
prudence and judgement.
WARNING:Product installation
This equipment must be installed in accordance with the
instructions in this handbook. Failure to do so could result in
poor product performance, personal injury and/or damage to
the vessel.
WARNING:Electrical safety
Make sure the power supply is switched off before making
any electrical connections.
WARNING:Electromagnetic energy
The radar scanner transmits electromagnetic energy. Ensure
that the scanner has been installed according to the
recommendations given in the relevant scanner handbook.
WARNING:Fishfinder sounder module
Removing the transducer cable from the rear of the fishfinder
sounder module whilst it is switched on can cause sparks. Only
remove the transducer cable after power has been switched
off. Ensure that the sounder module is mounted where it is
well ventilated and in an area free from flammable vapors.
87020-3.book Page i Tuesday, March 7, 2006 11:02 AM
To Next Page
Loading...
Need help?
General
