Raymarine C120 - Using Cable Splicers

Chapter 3: Installation 27
Using cable splicers
The cable splicers are used to make the connections from the SeaTalk/Alarm out and
NMEA 0183 cables easy and secure, without removing insulation from cable tails.
Note: Do not use cable splicers on any cables other than SeaTalk/Alarm out and NMEA 0183.
To use these connectors:
POWER
SEATALK 2
SEATALK
RADAR
NMEA
DSM
R
G
Y
IN
/ O
U
T
D6614-2
NMEA
(1.5m)
Power (1.5m)
Seatalk/Alarm out
(2m)
SeaTalk
2
Digital Sounder
Module (DSM)
Supplied
Not supplied/accessory
C-Series cable connections
cable splicer
D6615_1
87020-3.book Page 27 Tuesday, March 7, 2006 11:02 AM