24 C-Series Displays Installation Manual
Fixing bolts
When console mounting your C-Series Display, avoid damaging the rear trim ring by
using the correct length bolts. The length used is dependant upon bulkhead thickness:
Attaching the front bezel
After you have installed the C-Series Display in the required position, you should attach
the front bezel as follows:
1. Carefully lift one edge of the screen protection film, so that it is accessible for
removing when unit installation is complete.
Bulkhead Thickness (mm) Bolt length (mm)
0-3 12
3-7 16
7-11 20
11-15 24
15-19 28
19-23 32
D6760-1
87020-3.book Page 24 Tuesday, March 7, 2006 11:02 AM
To Next Page
Loading...
